409-1993
AMP-TAPETRONIC Machines 69875 and 69875-1
Rev J
35 of 46
Tyco Electronics Corporation
DO NOT drive the shear pin beyond the undercut portion or it will interfere with ram movement.
4. Replace the front guard on the machine before operating the machine.
8.5. Trip Control Replacement
Refer to Customer Manual 409–5128 for trip control replacement.
8.6. Tape Feed Belt Replacement
The tape feed belt teeth become worn. It is necessary to disassemble the lower portion of the tooling to replace
the belt.
Clean and lubricate the lower tooling, as described in Section 5, when the machine is disassembled for feed belt
replacement.
To avoid personal injury, turn off" the machine and disconnect the machine from the power supplies.
1. Remove the front and side guards from the machine.
2. Depress the wire funnel and pivot it away from the crimping dies.
3. Remove the dies as described in Paragraph 8.1.
4. Remove the wire stop head assembly.
5. Remove one cotter pin and washer, then remove pin assembly from the tie–rod end bearing. Refer to
Figure 30,B.
Figure 30
A
B
Lower Tooling Holding
Screws (Do Not Disturb)
Base Mount Adjustment
Screw (Do Not Disturb)
Wire Stop Head
Assembly
Base Mount Holding
Screws and Washers
Remove Base Mount
and Lower Tooling as a
Unit
Feed Yoke
Assembly
Adjustment Link
End Bearing
Holding
Screw
Pin Assembly
Tie Rod End
Bearing
Cotter Pin
and Washer
CAUTION
!
NOTE
i
DANGER
