409-1993
AMP-TAPETRONIC Machines 69875 and 69875-1
Rev J
25 of 46
Tyco Electronics Corporation
4. Replace the guards removed in Step 1 and connect machine to power supply.
5. Crimp a few products, being sure to insert a stripped wire into the wire barrel of each. If wire stop
does not clear product from upper die, additional adjustment may be made as described in Steps 5
through 7.
6. Disconnect power and repeat Step 1.
7. With the ram down, loosen the locknut on the adjustment screw, then turn the screw clockwise
(toward frame) approximately one full turn. Tighten locknut to secure screw.
8. Repeat Steps 4 and 5.
The ram lift pin may bend slightly when the adjusting screw is moved closer to the machine frame.
9. If necessary, repeat Steps 6 through 8 until the wire stop clears product from upper die.
Figure 20
Terminals
Butt Splices
Closed End Splices and Spare Wire Caps
A
B
C
D
E
F
No Adjustment
Necessary
No
Bellmouth
Turn Adjustment
Screw Clockwise
Too Much
Bellmouth
Turn Adjustment Screw
Counterclockwise
Wire Barrel Die Centered
Over Wire Barrel Of Splice
Insulation
Crimp Die
Splice Wire Barrel
Splice Out
Too Far
Splice In
Too Far
Turn Adjustment
Screw Clockwise
Turn Adjustment Screw
Counterclockwise
Die Centered Over
Wire Barrel of
Splice Or Cap
Wire Barrel
Splice or Cap
Out Too Far
Splice or
Cap In
Too Far
Turn Adjustment
Screw Clockwise
Turn Adjustment Screw
Counterclockwise
G
H
I
NOTE
i
