409-1993
AMP-TAPETRONIC Machines 69875 and 69875-1
Rev J
11 of 46
Tyco Electronics Corporation
Applied
Product
Supply
Materials Locations Ċ Plan View
Figure 8
Figure 9
Figure 8 shows proper location and position for foot and switch.
Figure 9 shows a typical layout for the efficient handling of materials.
3.3. Machine Installation
This machine is installed in the same manner as described in Customer Manual 409–5128. If the reel holder is
to be used, attach it with the same two screws that secure the guard to the right side of the machine frame as
shown in Figure 10,A. If a magazine holder is required, it must be ordered separately, then installed on the
bench with bolts or screws approximately 101 mm [4 in.] from the left side of the machine as shown in
Figure10,B.
4. OPERATION
4.1. Hand-Cycling Machine
(Figure 11)
During normal operation, the machine stops with the ram down (in “holding” position). The machine must be
hand–cycled on occasion for various adjustments. Hand–cycle the machine as follows:
The upper and lower tooling of the machine is aligned at the factory and will not normally require further adjustment. If,
however, the lower tooling holding screws or base-mount adjustment screws are disturbed, the dies will not align or
bottom properly, causing damage to the dies. Tooling alignment should be checked and adjusted by your local field
service engineer.
CAUTION
!
