Rev: 2013.09.15.v004a
9
Program the Throttle End Points per the
ESC Instructions and next couple steps….
Identify the porper pins for the; Throttle,
Aileron, Elevator and Rudder Channels.
Carefully compare to the diagram to make
sure you have the correct orientations.
Compare your Reciever to the included
diagram from the side as shown above.
Make a note of the polarity of the pins. In
most cases, either Black or Brown is used
to identify Negative (-).
Make a new program in your Radio. Zero all
the Trims and Subtrims. For starters all the
ATVs can be set to 100%. Adjustment of
additional settings will be done at the end
of the build.
Plug Motor wires into the ESC, the ESC into
the Throttle Channel, and the servos to
their appropriate channel. Bind per your
Radio’s Instructions.
turn on your radio and move the throttle
stick to "full throttle" position...
