Rev: 2013.09.15.v004a
17
Loosely fit the axle and one of the hex
nut shaped wood piece as shown above.
Note that some sticks out to the inside
and that it angles down to the work
surface as shown.
While in this position apply some
Welders and allow it to set up for a
couple hours. If in a hurry CA could be
used. Repeat for the other side.
Top View of axle alignment.
While the Axles are drying, you can cut
appart all the little foam pieces, and
install the elevator spar.
Completed View. Add additional
Welders for full coverave of the whole
area as needed. Note - Keep the axle
area where the wheel mounts free of
glue. Repeat for other side and let dry.
When the glue has set up enough to
handle, soak the axle area behind the
nut with Welders and wrap with thread.
