Rev: 2013.09.15.v004a
10
…. reconnect the battery to the ESC
and listen for two quick short beeps,
immediately following the beeps,
move the Throttle stick to low
position.
Next you should hear a series of
tones to indicate that programing is
complete.
Re-bind the system and double check
correct operation of all components.
Center all servos as close to 90 deg
as possible. Install the Longest single
arms on the servos.
Chose Flaperon Wing Type - this will
allow you to mix up and down aileron
with elevator and to use Flaps, more
detail on that later in the manual.
Program your radio so that the
channels & directions match the
picture above. Installed horns as
shown, dbl check that subtrims - arms
should be at 90 deg - mark the servos
Fold all the hinged parts over onto
themselves and let sit for an hour or so.
Locate the control rods and snap links.
After these are glued together, they
must dry for at least 24 hours, so build
them now.
