Rev: 2013.09.15.v004a
23
Install the adjustable links, install the
control rod. Snap the other ended into
the surface horn, center servo and
control surface. Snug the set screw.
Trim rods leaving about 3/4" extra.
If adjustments need to be made after
the build is complete, there is still
access to the adjustable link from the
outside of the fuselage as shown above.
Locate your wing servos and the short
control rods that were made at the
beginning of the build. Servos install
flush with the top of the wing. Route
wires in the pre-cut slots.
Attach the quick links to the servo
arms and the snap links to the aileron
control surface horn. Make sure the
servo and ailerons are neutral, snug up
the set screw, snip off any extra length.
Ideally the servo arm and the control
rod should form a 90 degree angle, or
at least something close.
Locate the elevator side force
generators. These glue on to the
inboard side of the counterbalance area
of the elevator, there is a tab to help
with location and position.
