Rev: 2013.09.15.v004a
19
Once the glue has tacked up, stick it to
the mating surface on the nose.
The small cowling part is next.
Seperate it from the larger part, and
glue to the nose, directly behind the
motor mount. This can be installed wet.
Tail Control Horns. There are two the
same, these are for the aileron, the
single shorter one is the elevator, and
the longer single one is the rudder.
Squirt some Welders into the slot and
install the horn as shown, flush with
the top, wipe away any extra glue.
Check on the under side that the
contour of the horn matches the
contour of the horn, they should be
flush, doing this ensures that the hole
in the horn aligns with the hinge line.
