Tuttnauer 6671130, Operation & Maintenance Manual

Page: 55 / 143

MAN205-0195042EN Rev. A Aug. 2011
Page 49 of 137 pages
4.3.3 System Setup (Changing Parameters and Values)
Note:

The system allows 15 seconds for values to be entered. If this time passes and
the panel has not been touched, the display will automatically move to the next
screen.

When codes are not entered within 15 seconds, the RUN and FAIL LEDs light
and the display returns to WAIT and then to the Stand BY screen.

If the code is incorrect the above will also occur.

When the display shows ØØØØ and a single value (between1-9) is to be
entered, the Ø must be pressed first. The single value cannot be entered on its
own; for example, to enter the number 4, the value is entered by pressing the
Ø three times and then the number 4.

When a value is to be entered, the right command key is ENTER:

If the value is entered via the digital key, after the final digit is entered, the
system automatically moves to the next screen, and ENTER need not be
pressed.

If the value is entered using the UP/DN keys, ENTER must always be pressed
to progress to the next screen.
The system setup includes the following functions:
Clock
– Date and Time, Language, Number of Doors, Door Type and Atmospheric
Pressure
To check that the system has correctly been set, press the OPTION key on the ST.BY
screen.
The screen displayed is as follows:
Press the SETUP key. The system requests a code.
Enter the code and the display automatically moves to the next screen after the last digit
is entered.