46
85816
SERVICE LEVEL MAINTENANCE
ERROR CODE NUMBER IS THE NUMBER OF RED LED PULSES
BETWEEN EVERY PAUSE.
THERE ARE NOT SERVICEABLE PARTS BEYOND THIS POINT.
PLEASE CONTACT YOUR SERVICE PERSONNEL FOR FURTHER
ASSISTANCE.
070-010-0181
USER ASSIST
DIAGNOSTIC
THE FOLLOWING CHART ASSISTS THE USER IN
TROUBLESHOOTING THE ELECTRICAL SYSTEM.
PLEASE REFER TO THE SERVICE MANUAL FOR ADDITIONAL
INFORMATION.
1 CAN COMMUNICATION ERROR
2 LOW TRUCK BATTERY
3 FAULTY CKT TO SPINNER OUTPUT
4 FAULTY CKT TO BELT OUTPUT
5 FAULTY CKT TO THROTTLE OUTPUT
6 FAULTY CKT TO SPIN PROP OUT
7 FAULTY CKT TO BELT PROP OUT
8 HIGH TEMP ERROR
PROBABLE CAUSE
ERROR
CODE
TURFCO PART
# 665965
RED ERROR CODE WARNING LIGHT
DIAGNOSTIC
ERROR CODE
LIST
SV85816-19
CAN
RECEIVER
FIGURE 34
CAN RECEIVER
EC01 = CAN COMMUNICATION ERROR
EC02 = LOW TRUCK BATTERY
EC06 = FAULTY CIRCUIT TO SPINNER PROPORTIONAL OUT
EC07 = FAULTY CIRCUIT TO BELT PROPORTIONAL OUT
EC08 = HIGH TEMPERATURE ERROR
NOTE: ERROR CODES EC03, ECO4 AND EC05 WILL NOT OCCUR
ON THE 85816 WIDESPIN
SYS STATUS: OK!
SYS STATUS: EC01
SYS STATUS: EC02
HIGH HEAT-SHUTDOWN
SYS STATUS: EC06
SYS STATUS: EC07
ELECTRONIC CONTROL BOX ERROR DISPLAYS
In all error codes, check the battery cables, and check the fuse.
EC07 Error: Check wiring and connections to hydraulic block valve PF2. Check
Solenoid. Check switch.
EC06 Error: Check wiring and connections to hydraulic block valve PF1. Check
Solenoid. Check switch.
EC02 Error: Truck Battery charge low, recharge battery.
OK! : No Errors Found.
EC01 Error: Check connections at base of CAN receiver. Check connection at
Electronic Control Box Cable
SV85816-28
E
E : “E” displayed during normal screen indicates an error is present.
Check for blinking red light on CAN receiver.
EC08 High Heat Warning: Trucks hydraulic system temperature above
205°F (96°C). Temperature too high to continue operation of the
top dresser. Shut down top dresser to allow the trucks hydraulic
system to cool.
CAN RECEIVER ERROR CODES
(See Figure 34)
Never attempt to open the CAN Receiver case, there
are no user serviceable parts inside. If the receiver has
failed or lost its programs, it will need replacement.
The CAN Receiver stores and processed the
programming to operate the electronic control box. The
receiver has two small indicator lights, one green and
one red. When the system is operating normally, the
green light will be on (a flickering of the light is normal).
In the event that an operating or physical problem
occurs, the red light will flash. The red light will flash
1 flash for error code EC01, two flashes for error code
EC02, and so on up to 8 flashes for error code EC08.
The red light will blink the code, then pause and repeat
the pattern.
The CAN receiver will also send the same error code to
the control box display. Note an “E” in the first digit space
on the display. This indicates that an error is detected.
The error code can be viewed in the display by pressing
and holding the lockout button while toggling between
screens with the “B” and “C” preset buttons. Compare
the code to the list on the front of the CAN receiver.
