Turbosol TB30, Use And Maintenance Manual

Page: 57 / 87

USE AND OPERATION
5
561405 - IS19/07 - EN
57/87
Tab. 5-2
1
PUMPING PRESSURE GAUGE
It indicates the hydraulic pressure of the pumping circuit.
2
S VALVE PRESSURE GAUGE
It indicates the hydraulic pressure of the S valve circuit.
3
SERVICES CIRCUIT PRESSURE GAUGE
It indicates the hydraulic pressure of the agitator, of the high pressure washer
and of the hopper discharge.
4
HYDRAULIC OIL TEMPERATURE / LEVEL INDICATOR
It indicates the level and temperature of the hydraulic oil contained in the tank.
5
ACCELERATOR LEVER
Pushing the lever down increases the engine’s speed.
Pushing the lever up decreases the engine’s speed.
6
OUTPUT REGULATION LEVER
Turning the knob adjusts the concrete flow rate.
7
AGITATOR REVERSAL / DRIVE LEVER
Stable position. Drive: In this position the agitation of the material in the
hopper is activated.
Stable position. Reversal: In this position the agitation reversal of the material
in the hopper is activated.
8
HIGH PRESSURE WASHER LEVER
Stable position. Activating the lever activates the high pressure washer.
9
HOPPER DISCHARGE LEVER
Unstable position. Activating and holding the lever opens/closes the hopper
discharge shutter.
10 -
BATTERY CUT-OFF SWITCH
It is positioned inside the engine compartment, near the battery. It disconnects
the power supply. Turn the knob clockwise to feed the electrical system. Turn
the knob anti-clockwise and pull out to disconnect the electrical system from
the battery. With knob extracted, insert the cap to protect the internal contacts
of the device.
11 -
REMOTE CONTROL SOCKET CAP
It is located on the left part on the fixed bodywork, before the controls side
door. It must always be inserted on the socket in order for the machine to
work. It contains an electric circuit for the machine emergency circuit.