Turbosol TB30, Use And Maintenance Manual

Page: 29 / 87

SAFETY AND PREVENTION
3
561405 - IS19/07 - EN
29/87
Do not touch the machine hot parts, such as the silencer or radiator. Wait at least two hours after turning off
the engine.
To prevent fire, pay attention to possible leaks of flammable substances, for example from hydraulic pipes
and fuel pipes.
DANGERS ARISING FROM THE PROJECTION OF PRESSURISED FLUIDS
The sources of danger are the concrete conveying pipes.
The arising dangers are:
- cutting of the pipes;
- projection of fluids with consequent damage to the eyes and/or parts exposed to the projection.
Verify daily the integrity of the pipes connected to the machine (conveyor pipes). If in doubt, replace with
new and original ones. The control procedure is described in the maintenance chapter.
Check the rubber gasket is present, fully fasten the lever and insert the safety pin when connecting the
piping segments (Fig. 3-4)
1
2
3
3
Do not disconnect the material conveying pipes from the machine if they are pressurised. Always discharge
the residue pressure and then disconnect them. In the absence of pressure the pipes sag when stepped on.
DANGERS ARISING FROM CONTACT WITH THE LUBRICANTS
Refer to the residual risks in the Maintenance paragraph.
DANGERS ARISING FROM THE USE OF FUEL (DIESEL)
The dangers arising from the improper use of fuel (diesel) and its container are:
- slipping and falling;
- skin irritation;
- fire.
Accidental leaks make the surface very slippery. Clean adequately.
Wear adequate accident-prevention clothing when handling the fuel.