TurboLock TL88 10
Part 2 - Disassemble the Lock
The TL88 comes already assembled.
Before installation, release the inside
screws and mounting screws to
disassemble the lock into three main
parts: Outside Knob x 1, Inside Knob x
1, Latch Assembly x 1.
Part 3 - Installing the Latch
Step 1.
Insert the latch into the hole. Using a pencil, mark a line around edge of latch plate to
use as a guide. After marking at all four sides of the plate, remove the latch
(Fig. 8).
Step 2.
Chisel about 3mm (0.1”) deep or until latch plate sits flush with door edge
(Fig. 9).
During chiseling, it’s highly recommended to stop and reinsert the latch every once in a while
to see if it sits flush. If not, chisel a little more and check again. Be careful not to chisel too
deep; otherwise, the lock may not function correctly after installation.
(Fig. 9)
Outside Knob
Latch Assembly
Inside Knob
(Fig. 8)
