8
Owner
’s manual
•
PLA
TINUM PRO
Install the Release Lever (40) onto
the Seat Handle Bar (6) just behind
the hand pulse sensors. Install the
lever at an angle that allows easy
access for use, then install and
tighten the socket screw removed
earlier.
5. Secure the Steel Cable (58) on the
Seat Handle Bar (6) by using the four
strips of Velcro Tape.
6. Plug the Handpulse W/Cable
Assembly (21, 27) into the sockets
located on the left side rear cover
(26), just under the seat..
7. Install the Beverage Holders (R /38,
L/39) onto left of the Seat Handle Bar
(6) with four Ø4 × 16mm Sheet Metal
Screw (105).
8. Install the Pedal (L, R) (116, 117)
onto the Crank Arm (L, R) (51L, 51R).
Step 3:
Seat, backrest, pedals and Small
Covers
1. Install the Seat (61) on the Seat
Carriage (4) with four M6 × 15mm
Phillips Head Screws (98).
2. Install the Front Support Cover (32)
and the Rear Support Cover (37) on
the Main Frame (1) with four M5 ×
12mm Phillips Head Screws (99).
3. Install the Gas Cylinder (57) into the
bracket of the Seat Back Frame (5)
with one M8x32mm Hex Head Bolts
(70), one 5/16” × 18mm Flat Washer
(76), one 5M8x6T Nyloc Nut (91).
Tighten the bolt until snug, but do not
over tighten to the point of binding.
4. Remove the M6 Button Head Socket
Bolts holding the clamp of the seat
adjustment Release Lever (40).
