TL60ECV
-
Section 20: Option - Laser Guidance System 20-1
Section 20: Option - Laser Guidance System
Laser Guidance Installation
Refer to
Parts Manual
to ensure all parts are included.
To install your Laser Guidance System on a balewrapper follow these instructions:
1. The laser sensor and mount assembly must
be mounted to the rod side of the front
steering cylinder. The pin holding the front
steering cylinder rod end in place will need to
be removed to allow the laser sensor mount
bracket to slide between the cylinder rod end
and the sliding tube lug.
2. Reinstall cylinder pin.
3. The communication cable must be routed
down the door mount and hoop brace and
along the balewrapper frame, up the door
mount and hoop brace to the control panel. It
must then be connected to the mounted laser
sensor.
NOTE:
It may be possible to route the
communication cable along side existing wires.
4. Enable the laser guidance option using the
control screen Parameters page, see
Fig .1
Summary of Contents for TL60ECV
