TL60ECV
-
Section 14: Option - Plastic Film Sensor 14-1
Section 14: Option - Plastic Film Sensor
Film Sensor Installation
Ensure all parts have been received. Refer to
Parts
Manual
.
1.
Install film sensor bracket
(A)
by sliding into frame
tube and locking with provided bolt
(B)
. See
Fig.1
.
2. Locate the “Film Sensor” wire attached to frame.
3.
Remove plug from frame film sensor wire.
4.
Connect frame film sensor wire plug and film sensor
switch harness.
Fig .1
A
B
Plastic Film Sensor Adjustment
Sensor wire must be adjusted so that only one layer of plastic is covering the end of the wire while
wrapping. Adjustment can be made on the bracket and on the sensor wire. The end of the sensor wire
behind the switch can be bent to allow the wire in front of the switch to drop down far enough to trip
the switch when no plastic is present.
NOTE:
Use measurements as initial guide only.
• Measure length of wire from the hoop face (see previous page)
• 9.5” wire = approx. 3” between wraps = 8-9 layers per bale
• 9.5” wire should stop hoop rotation just after an empty tensioner passes the wire
• Lengthen wire 3” for 4 layers of wrap or 1.5” for 6 layers
• Shorten wire by 1.5” for 10 layers per bale
NOTE:
As a guide, if the hoop stops before an empty plastic film carrier passes the film sensor wire,
the wire is too short and if the hoop does not stop with one empty plastic film carrier the film sensor
wire is too long.
Summary of Contents for TL60ECV
