13-1
Section 13: Option - Remote Control -
TL60ECV
Section 13: Option - Remote Control
Remote Control Installation
• Bolt receiver circuit board assembly
(A)
inside control panel so antenna sticks through top of
control panel.
• Connect remote antenna harness plug to matching control panel harness plug.
NOTE:
All remote control units use the same frequency, no programming is required.
NOTE:
Remote requires 2 AA batteries. Avoid rechargeable batteries, as the chemicals in these
interfere with remote signals.
Remote Control Operation
Set control panel switch to “Remote Engine Start”
ON/OFF
– Turns handheld unit on/off (detent has no function).
START
– Starts the wrap cycle (unplug the table switch if you prefer to start each cycle with this
button), this will not restart the hoop if cycle is broken after Hoop Start was triggered.
STOP
– Stops the wrap cycle (if the table switch is not unplugged and it has a bale holding it down, it
is necessary to hold stop until the circuit is broken by switching to manual mode at the control panel).
LEFT
- Steers front tires left.
RIGHT
- Steers front tires right.
Refer to Information page on display screen,
NOTE:
Store remote control inside tube marked “REMOTE ENCLOSED” on right side of machine
when not in use.
START
LEFT
STOP
RIGHT
ON
OFF
Summary of Contents for TL60ECV
