4-7) Install the Front Panel onto the Control and I/O components. Install one nut onto the INTENS potentiometer. Install jack nuts on Out 1,
Out 9, and INTENS. Install the nut on the INV/NORM switch. Make sure that the RESET pushbutton operates freely. At this point, solder one
pin of each component, EXCEPT for the LEDs. DO NOT solder the LEDs yet:
4-8) Flip the assembly over to check that all of the Control and I/O components are still fush against the PCB and the Front Panel. If not,
make adjustments. If so, complete soldering all of these components except for the LEDs. Because of some taller components on the BLUE
Signal PCB, be sure to trim the leads for PB_RESET and VR_MODE [circled in RED] – then re-fow solder as needed:
DIY Build DOC/BOM
KOSMODROM CHAOS DIVIDER
V 1.4
Page 29