4-9) Slide the LEDs towards the Front Panel until they are through the PCB and stopped by their “shoulder” against the back of the Front
Panel. Once the LEDs are in place, solder them to the PCB. After soldering them, it's a good time to clean the back:
4-10) Remove the Front Panel from the Control PCB. Since they are no longer supported by the front panel, be gentle with the LEDs:
4-11) Install three of the female/female stand-ofs with three of the M3 x 6mm screws onto the back of the Control PCB:
DIY Build DOC/BOM
KOSMODROM CHAOS DIVIDER
V 1.4
Page 30
