1-3) The third item that we will check is the WHITE Control PCB. All of the user IO and Control devices for the Chaos Divider are on this PCB
[front and back sides are shown]:
1-4) Next, we will inspect the Chaos Divider Front Panel. Check for chips or fakes in the powder coated panel as well as any issues with the
screen printing. It should look like this:
NOTE:
The Chaos Divider's front panels are printed with solvent based inks. Do not use solvents such as Naphtha, VM&P, Isopropyl Alcohol
[or any other solvent or solvent based cleaners not listed] to clean the front panel. There is a really good chance that you will remove the
printing from the panel.
ALSO OF NOTE:
There are four Mouser carts for this build. One for each of the PCBs and one for miscellaneous hardware such as fasteners
and stand-ofs. Be sure to get
ALL
of them.
DIY Build DOC/BOM
KOSMODROM CHAOS DIVIDER
V 1.4
Page 3
