Note:
The last bit of assembly before Power Supply testing is to install the rest of the male pin headers for the Power/Logic PCB. The rule of
thumb for the internal headers in this module is that the male headers are on the top of the PCB and the female headers are on the back of
the PCB.
2-15) Match up the male and female header pairs that connect the Power/Logic and Signal PCBs. Match up the 1x3 pin headers MHDR_NBL
and FHDR_NBL, the 1x5 pin headers MHDR_OUTPUTS2 and FHDR_OUTPUTS2, the 1x6 pin headers MHDR_OUTPUTS1 and FHDR_OUTPUTS1,
and both 1x10 pin header sets MHDR_INPUTS/FHDR_INPUTS, and MHDR_NIXIE/FHDR_NIXIE:
2-16) Install two of the female/female stand-ofs and two of the female/male stand-ofs into the Power/Logic PCB so that the stand-ofs
are on the front side of the PCB and the M3 x 6mm screws are installed through the back of the PCB:
DIY Build DOC/BOM
KOSMODROM CHAOS DIVIDER
V 1.4
Page 11
