Page
34
of
110
Configuring the SAM-Q-SDI
The following pages include information on how to configure the SAM-Q-SDI using its front panel controls
and internal configuration menus.
Please note that some configuration menus and their associated parameters may only be accessed or
modified if the relevant license option has been installed.
Information on how to check the current license status of your SAM-Q-SDI and for instructions on how to
install optional licenses please refer to the Licenses Menu on page 70
Recommendations for Configuring your SAM-Q-SDI
The following recommendations are by no means exhaustive but are intended to act as a quick step by step
guide to getting your SAM-Q-SDI up and running a.s.a.p.
1.
In the
Network Setting Menu
, enter a unique name for your SAM-Q-SDI. This could be based on
its location or position within a facility (i.e. EDIT 1, MCR 2), or its owner (DAVE, FRED, BOB).
Applying a unique name to your SAM-Q-SDI will help identify the unit to a) the user, b) over an
Ethernet network (i.e. when using SAM-Q-ADMIN or when accessing Loudness Data), c) when
using SAM- Q-EDIT and d) when contacting TSL Support.
2.
Check the
License Menu
to ensure that the SAM-Q-SDI has the License options you require. If not,
please contact TSL Support so that these can be installed.
3.
In the
Inputs Menu,
make sure that the BNC Inputs are set as required.
4.
In the
Mode Permission Menu
, Disable any Operational Modes that will not be required to meet
the requirements of the application, task or user.
5.
In the
Mix Permissions Menu
, disable those MIX Groups not required to meet the requirements
of the application, task or user.
For further information on SAM-Q-ADMIN and SAM-Q-EDIT, please contact TSL Support.
