CHAPTER 2: ASSEMBLY GUIDE
Truefitness.com / 800.426.6570 / 636.272.7100
17 of 41
ASSEMBLY STEPS:
Step 3 Attach Rear Step:
Step 4 Attach Draw Bars:
a) Insert the step weldment into the rear
openings making sure the screw holes
face up.
b) Using the 2 M10x50 bolts and 2 M10
nuts, attach the weldment.
c) Attach the plastic step using the 4
M5x12 stainless bolts.
Hardware Required (Bag 3):
a) Slide correct drawbar onto
corresponding shaft.
b) Install, but do not tighten a M10
bolt, lock washer, and flat washers with
17mm socket and wrench.
c) Repeat these steps for both sides.
Hardware Required (Bag 4):
d) Secure bottom of drawbars using 4
M8x 12 bolts and 4 M8 curved washers.
e) Once all bolts are started, tighten
bottom bolts with 6mm allen wrench
and top bolts with 17mm socket and
wrench.
Hardware Required (Bag 4):
2 M10 Nuts
2 M10 Bolts
8 M8 x 12 Bolts
8 Curved Washers
4 M5 x 12 Bolts
*Drawbars are labeled “L” for left and “R” for right.
2 Flat Washer
M10 x 50 Bolts
2 Lock Washer
M10 x 50 Bolts
M10 Nuts
M5 x 12 Bolts
