CHAPTER 2: ASSEMBLY GUIDE
Truefitness.com / 800.426.6570 / 636.272.7100
15 of 41
ASSEMBLY STEPS:
Step 1 Assemble Pedestal to Base:
a) Remove 3 screws in order to remove
inner shroud from both inner sides.
b) Remove the twist tie from the Rubber
seal and slide it up over the weld beads
to its correct location. Make sure “Up”
tab is facing up on the rear of the
machine.
NOTE: The rubber seal is for
perspiration deflection and should sit
below the plastic covers.
c) Use 2 people to slide the Pedestal
straight down onto the Base and be
careful to not pinch the wires on the
right side of the base.
Remove inner
shrouds by removing
3 screws per side.
“This side up” tab
Rubber Seal
Pedestal
Front and Back
Bolts
Inside Bolts
