Trox Technik SCHOOLAIR-S-HV, Installation And Operating Manual

Page: 14 / 56

5 Transport, packaging and
storage
5.1 Safety notes
Suspended loads
DANGER!
Danger of death due to suspended loads!
Falling loads may cause serious injury or death.
Therefore:
– Never walk under suspended loads.
– Only move loads under supervision.
– Observe the specifications for the intended
lashing points.
– Ensure that the lifting gear is secure.
– Only use approved hoisting devices and lifting
gear with sufficient load-bearing capacity.
– Do not use any frayed or worn ropes and belts.
– Do not place ropes or belts near sharp edges or
corners; do not knot or twist.
– Place the load on the ground before leaving the
workplace.
Damage to goods being moved
NOTICE!
Risk of damage to property due to the incorrect
handling or lifting of units!
If you handle or move packages incorrectly, they
may topple or fall. This can cause considerable
damage to property.
– Be careful when unloading the packages upon
delivery and during internal transport, and pay
attention to the symbols and information on the
packaging.
– Do not put down packages hard and do not
knock against them with force. In the prices,
watch out for protruding parts of the packages.
– The forks of forklift trucks must drive completely
under packages.
– Do not remove the packaging until immediately
before assembly.
5.2 Factory condition
The device is delivered packed on two pallets. The
lower and upper parts of the device must be joined
together at the installation site,
Ä
6 ‘Installation’
on page 16 . In the process, the serial number of
the devices must be observed,
Ä
Chapter 3.2 ‘Rating
plate’ on page 10 . Only join components with the same
serial number.
Accessories are packed and enclosed separately if nec-
essary.
The packaging is suitable for transport to the intended
destination.
Fixing and installation material
Fixing and installation material is not part of the
supply package (unless stated otherwise), but has
to be provided by others; it has to be suitable for the
installation situation.
5.3 Checking delivered goods
Check delivered items immediately after arrival for
transport damage and completeness.
If there is any visible damage, proceed as follows:

Either do not accept the delivered items, or accept
them with reservations.

Note down the damage on the shipping documents
or on the shipping company's delivery note.

Immediately file a complaint with the shipping com-
pany and vendor.
Complaint of defects
Complain about any defect as soon as it is discov-
ered. Claims for compensation can be filed only
within the complaint period.
5.4 Transport to the installation loca-
tion
Protective equipment:

Safety shoes

If possible, do not remove the unit from the pallet
until you reach the installation site.

Use a pry bar and pincers to unpack the unit from
the pallet.

If the unit is transported without a pallet, the foil
packaging must remain on the unit until it is installed
on site to protect against damage to the paintwork.
Transport, packaging and storage
Transport to the installation location
Decentralised ventilation units SCHOOLAIR-S-HV 14