EN
Infrared Camera – Operating Manual
B -
22
09. Care and MaIntenanCe
Use the following procedures to clean the camera
housing, lens, LCD monitor and other parts.
Camera housing
Wipe the housing with a clean, soft, lint-free cloth or
eyeglass wipe.
Lens
Use a blow brush to remove any dust from the lens and
use a clean, dry cloth to remove any dirt or particles that
may still be on the lens. Do NOT use caustic cleaning
agents to clean the camera housing or the lens.
10. trOuBLeshOOtInG
problem
Cause
solution
Camera does not operate.
Power is not turned on.
Turn on the camera.
See Turning the Power On / Off.
Insufficient battery voltage.
Fully charge the battery.
Poor contact between camera and
battery terminals.
Wipe the terminals with a clean,
dry cloth.
The camera firmware has frozen
up.
Perform a RESET.
Camera will not record.
Internal memory is full.
Save the images onto your
computer and delete them from
the SD card.
Internal memory not formatted
correctly.
Format the memory
in FAT32 format.
Battery power exhausted.
Battery capacity reduced
because battery was not used for
a year or longer after being fully
charged.
Replace the battery with a new
one.
Battery life is at the end of its life.
Replace the battery.
Battery will not charge.
Poor contact between battery and
battery charger.
Clean the battery terminals with
a clean cloth. Connect the power
cord to the battery charger and
insert the plug firmly into the
power outlet.
Battery is at the end of its life.
Replace the battery.
LCD monitor
Use a lens blower brush to remove dust and dirt. If ne-
cessary, gently wipe the LCD monitor with soft cloth or
an eyeglass wipe to remove stubborn dirt.
Never rub or apply pressure to on the LCD monitor. This
may cause damage or result in other problems.
Never use thinners, benzene, synthetic cleaners or water
to clean the camera. These substances may cause de-
formations or damage the equipment.
