EN
Infrared Camera – Operating Manual
B -
14
Saturation colour
When activated, the width of the image with the high-
est temperature is coloured green.
Isotherm width
Sets the width of isothermal intervals. The width can be
adjusted from 0.1 to the upper limit of the maximum
temperature measurement range under this condition.
Isotherm colour
Sets the colour of the isotherm interval to either
green, black opr white or to transparent.
Isotherm type
Isotherm
Type
Dual
Above
Shows all temperatures within the set
isotherm intervals in one colour and in
addition all areas which are warmer than
the upper interval threshold in a different
colour.
Dual
Below
Shows all temperatures within the set iso-
therm intervals in one colour and in addition
all areas which are colder than the lower
interval threshold in a different colour.
Above
Shows the isotherm interval and all areas
which are warmer than the upper interval
threshold in the same colour.
Below
Shows the isotherm interval and all areas
which are colder than the upper interval
threshold in the same colour.
Interval
Shows the set isotherm interval in one
colour. The rest of the image is displayed
in IR pseudo colours.
Isotherm alarm
The alarm threshold value can be set between 1 and 100
and describes the proportion (in %) between 1/100 and
100/100 of the area of the LCD, eg. the isotherm range
is between 35°C and 40°C and the Iso-Alarm is 100. In
this case the alarm is triggered when 100% of the area
shown in the LCD is between 35°C and 40°C and the
whole area of the LCD is correspondingly “isotherm”- co-
loured. If the alarm threshold value is set, for example, at
40, the alarm will be triggered when 40% of the area of
the LCD is “isotherm”- coloured.
Spot analysis
The following subject matter briefly explains how to
set the analysis tools on the thermal image.
1. Press the MENU/ENTER key.
2. Press the up
s
or
down
t
key on the
omni selector to get to
the menu item [Analy-
sis].
3. Setting the spot analysis
• Press the up
s
or
down
t
arrow on
the omni selector
to select a spot,
then press MENU/
ENTER key. One or
more crosshairs will
appear on the screen.
• Spot 5 will automatically track the highest or
lowest spot on the screen.
4. Moving the analysis spot
• Start from Step 1 to
set or select a spot
analysis.
• Press the up
s
,
down
t
, left
,
right arrow on the
omni selector to
move the activated
spot.
Temperature value
of the current spot
will be modified
5. Removing the meas-
uring spots.
• Start with Step 1
and select the meas-
uring spot you wish to remove.
• Press C to remove the measuring spot.
tracking the measuring spot
Set Spot 5 or Spot 10 so that it tracks the highest/
lowest point on the display.
Measured
Temperature
