Triumph Adler DC 2218, Advanced Operation Manual

Page: 103 / 148

System Menu
3-23
5 Press the Enter key.
6 Press the Reset key. The message display returns to the copier basic screen.
Administrator Management Code Change
You can change the four-digit management code for the administrator of this machine.
Important!
• If you change the management code, be sure to note it. If you should forget the management
code, contact your service representative.
• The management code at the factory default setting is
1800
for the 18 ppm model and
2200
for the 22 ppm model.
1 Display the
Machine default
screen. (See How to Display the Machine Default Screen on
page 3-12 .)
2 Press the S key or the T key to select
PIN #
Change
[
MGMT Code entry
].
3 Press the Enter key.
4
Use the numeric keys to input the new administrator
management code.
5 Press the Enter key.
6 Press the Reset key. The message display returns to the copier basic screen.
Auto Sleep
The machine enters automatically the sleep mode when the preset time elapses without any
operation if this setting is turned
On
.
Notes
• This setting is displayed only on the inch specification machine.
• You can disable the auto sleep function if this function causes inconvenience. It is
recommended, however, to set a longer time that elapses before the auto sleep function is
activated, before disabling this function.
1 Display the
Machine default
screen. (See How to Display the Machine Default Screen on
page 3-12 .)
2 Press the S key or the T key to select
Auto Sleep
.
3
Press the Enter key.
4 Press the S key or the T key to select
On
or
Off
.
08:48 :
:
PIN # Change
Display Contrast
Date/Time:
Machine Default :
Management Code Change
1 8 00
# keys
On :
:
Auto Sleep
Machine Default :
PIN # Change
Display Contrast
Auto Sleep :
Off
On
*