TriPoint VertexRSI 7200, Operation And Maintenance Manual

Page: 74 / 266

7 2 0 0 OPERA TIO N
5 - 6
5.4.2 Conf ir m a t i on M e ss a g e s
Depend i ng on the sett i ng of the user i nterface opt i ons parameters (refer to
paragraph 5.8.6.1 1), the system w ill d i sp l ay track i ng and ed i t i ng conf i rmat i on
messages, and a w arn i ng be ll may be operat i ona l to a l ert the user that a
conf i rmat i on message a w a i ts a response. The be ll w ill a l so sound w hen an i nva li d
key i s pressed.
NOTE:
Th e d e f a u l ts fo r th e c onf ir m a t i on m e ss a g e s a r e s e t
so th a t th e m e ss a g e s a pp ea r . Fo r a ll op e r a t i ng p r o ce du r e s i n
th i s m a nu a l , i t i s a ssum e d th a t th e d e f a u l ts a r e un c h a ng e d
a nd a ll c onf ir m a t i on m e ss a g e s w ill a pp ea r .
The fo ll o w i ng i s an examp l e of a track i ng conf i rmat i on message:
Stop t r ack i ng a nd r e tu r n to st a ndby ?( y e s/no ) YES
[ YES/NO ] c h a ng e s YES/NO r e spons e . [ ENTE R ] acce pts d i sp l a y e d YES/NO r e spons e .
5.5 P a r a m e t e r a nd D a t a Sto r a g e
A ll parameters (target-spec i f i c and system) are stored i n battery-backed nonvo l at il e
RA M on the CPU board. Th i s i nc l udes a ll accumu l ated steptrack data.
In add i t i on, w hen the A C U i s po w ered up, i t automat i ca ll y resumes track i ng the
target that i t w as track i ng at the t i me the system w as po w ered do w n. If the A C U
w as i n Standby at that t i me, i t rema i ns i n Standby. There i s a f i ve-second de l ay
from the t i me the A C U comp l etes po w er-up and i s ready to be commanded and
w hen track i ng resumes on the target that w as be i ng tracked at po w er-do w n t i me.
Th i s g i ves the user the opportun i ty to return the un i t to Standby before antenna
movement starts.
5.6 P ow e r -Up P r o ce du r e s
Before proceed i ng w i th these po w er-up procedures, be sure that Sect i on 4.0,
Insta ll at i on, of th i s manua l has been used to i nsta ll , set up, and conf i gure the
system.
To po w er up the 7 2 0 0 A C S, use the fo ll o w i ng procedures.
1. On the 7 1 5 0 Dr i ve C ab i net, pu ll the EMERGEN C Y ST OP s w i tch to the out
pos i t i on.