27
D01-051en202111 Manual TriBox3
Advanced
Use
Malfunction & Maintenance
Commis- sioning
Introduction
General
Information
FA
Q
Technical Data
W
arranty
Customer
Service
Contact
Keyword
Index
Accessories
Use
TriBox3
//
Use
4.3 Connection of the Sensors
As standard, the TriBox3 offers four serial sensor interfaces, COM1 to COM4. Customized extensions are
available to connect additional sensors. Only original cables from TriOS Mess- und Datentechnik GmbH may
be used to connect the sensors. Connect the cable of your TriOS sensor to a COM port on the TriBox3. Insert
the M12 connector plug into the desired COM port and secure the connection by fastening the fitting (see the
figure below).
The respective settings of the individual COM ports are visible in the green fields of the COM ports.
Connecting a sensor should always be done in maintenance mode.
NOTICE
For analogue sensors, a TAMMO module (for TriBox3 with 8-digit serial number AdamE) can
additionally be installed, which converts analogue signals into the RS-485 Modbus RTU proto
-
col (see the respective quick start guide).
Summary of Contents for TriBox3
Page 1: ...TriBox3 OPERATING INSTRUCTIONS...
Page 2: ......
