10
D01-051en202111 Manual TriBox3
Use
Advanced
Use
Malfunction &
Maintenance
Introduction
General
Information
FA
Q
Technical Data
W
arranty
Customer
Service
Contact
Keyword
Index
Accessories
Commis-
sioning
Commissioning
//
TriBox3
3.3 Outputs
The TriBox3 has six analog outputs. The four cable glands at the bottom left of the image are not normally
assigned, whereas the lower right cable bushing is intended for the mains power cable and therefore also has
a larger cross section. When delivered, the mains power cable is already installed at this location. The upper
right cable bushing is intended for the relay.
1. RS-232 TX / RS-485 A
2. RS-232 RX / RS-485 B
3. not connected
4. not connected
5. not connected
6. +12 VDC
7. GROUND
8. +24 VDC
3.4 Menu
After installation, the TriBox3 can be switched on by switching on the power supply.
3.4.1 Main Menu
The main menu can be seen in the navigation bar on the right side of the display. This is always visible regard
-
less of the submenu currently displayed, so that the user can switch between menu items at any time.
Sensors and COM ports Display and settings
Display configuration
System settings
Export and import of data
Device information and support contact
Switch off display or restart TriBox3
M-12 industrial plug
Cable bushing for relay
Cable bushing for analog outputs and triggers
The designations of the data lines can be seen from the TriBox3. For example, RS-232 RX is
the receiving line and RS-232 TX is the transmission line of the TriBox3.
Summary of Contents for TriBox3
Page 1: ...TriBox3 OPERATING INSTRUCTIONS...
Page 2: ......
