Trinnov Audio D-MON 12, User Manual

Page: 57 / 95

7.2.1 PREPARING THE MATRIX
The diagram below shows how the matrix sources and destinations are affected by the SESSION SETTINGS and STUDIO SETUP :
The available sources are determined by the SOURCES in the SESSION SETTINGS page. The available destinations are
determined by both the SESSION SETTINGS page (MIX BUSES and OUTPUTS) and STUDIO SETUP -> Speaker Sets (SPEAKERS).
Therefore, you will need to configure both of these pages before setting up the matrix.
Note that:
•
The headphones ( PHONES ) always appear as a destination.
•
The PATCH “eye” icon (in the STUDIO SETUP -> Speaker Sets ) must be enabled to view a speaker set in the matrix.
•
The
PATCH
“eye” icon (in the
SESSION SETTINGS
) must be enabled to view a source, mix bus or output in the matrix.
•
A mix bus will appear as both as a source and a destination. This allows you to assign sources to a mix bus, and the same
mix bus to its physical destination.
•
If you assign a source to a mix bus in the SESSION ROUTING matrix, then this is reflected in the MONITORING MIXER page,
and vice versa. See 7.3: MONITORING MIXER.
7.2.2 SAVING SETTINGS (IN SNAPSHOTS & PRESETS)
All assignments made within the SESSION ROUTING matrix are saved in both snapshots and presets.