5
QUICK START
This chapter provides a
quick start
to get you up and running as quickly as possible.
We will assume that the D-Mon processor is already installed and configured – i.e., all connections made; all speaker sets
defined and calibrated; the correct clock signal selected; etc. If not, please see
Note that all the functions of the D-Mon Control Panel GUI are covered in more detail later in
Chapter
5.1
POWERING ON / BOOTING UP
Providing the processor has been fully installed and configured, it can be booted from the front panel.
Press the front panel
ON/OFF
button to switch
ON
the processor:
You will hear a click from the internal relay, and the
ON
button illuminates as shown above. The processor will take a few seconds
to boot, so please wait a little while before opening the GUI.
At the end of the boot-up procedure, the processor recalls a specific preset (see
7.6.5: Setting the Default Preset
.) This should
reset the processor’s configuration so that it meets the needs of your studio.
ATTENTION!
To turn off the unit,
ALWAYS
use the front panel
ON/OFF
button to shut down the processor
BEFORE
switching off the
mains power.
Turn ON here
