Trinity Highway REACT 350 II, Product Description Assembly Manual

Page: 27 / 68

TrinityHighway.com 26 Revision E November 2020
3) Drill and Set Side Anchor Plate Anchors
Warning:
For REACT 350 ® II with a Concrete Backup, Side Cable Anchor Plates
must be attached.
Warning:
The vertical placement of the Side Anchor Plates is critical to the
performance of the REACT 350
®
II. If an existing backup is not tall enough to fulfill
these requirements, special brackets are available. Consult Trinity Highway
Customer Service for further information (p. 3).
When correctly assembled, the top of the Side Cable Anchor Plates should be 39” [991 mm]
from the road surface. The front edge of the Side Cable Anchor Plates should be 2” - 4”
[51 mm - 102 mm] from the front face of the backup to avoid reinforcing steel. The tapered
tubes of the Side Cable Anchor Plates should face the front of the REACT 350
®
II (Figure 20).
Use the holes in the Side Cable Anchor Plates as templates to match drill ten (10) holes per
side of backup, 7/8” [22 mm] diameter x 5 1/2” [140 mm] deep into the Concrete Backup.
Use
an approved adhesive kit to place
twenty (20) 3/4” diameter x 6 1/2” long studs using
instructions included with kit.
After adhesive has cured, use 3/4” flat washers and nuts
provided with kit to attach side cable anchor plates (one on each side) to Concrete Backup
(Figure 20).
Figure 20 - Side Cable Anchor Plates
39" [991 mm]
3" [76 mm]
Side Cable Anchor Plates
PN 614195
Tapered Side