TRI TOOL INC.
92-1739 Rev. 220506
34
Install the Drive Motors
1.
Install the required Motor(s) and the Drive Housing(s), into the Slots. The Motor
Mounts react to the torque of the Motor only when the Motor Holdown Bolts are
in place.
2. Bolt the motors to the Clamshell.
3. Ensure that the Clamshell can rotate clockwise when viewed from the
Headstock front face.
4. Be sure that the Hydraulic motor pressure hose is connected to Port B and that
the return hose is connected to Port A.
5.
Unbolt the two Red Lock Blocks attached to the headstock.
6. Flip them over.
7. Attach them with the dowel pin pointing outward. The headstock can rotate.
8. Connect the correct power supply to the Model 600RBL-G2.
9. Rotate the Headstock slowly with the Tripper Shaft pushed in for one full
revolution to ensure that the Tripper Shaft is aligned with the Sprocket so that
the Tripper shaft connects with the Sprocket on all Tool Blocks.
DANGER
DANGER: Wait for the rotating tool block to pass the tripper block before you push the
tripper shaft. If your hand is in the path of the tool block, before it passes the tripper
block, this can result in serious personal injury.
DANGER: Do not put your hands or other parts of your body on the drive housing or the
tripper bracket assembly when the head stock is rotating. Serious personal injury can
occur.
CAUTION
CAUTION: The tripper shaft must strike the sprocket on the edge of the tooth or the
clamshell can break the tripper shaft, the sprocket, or both.
Select and Install Tool Bit Set
Refer to section 10 for a description of Tool Bit Sets. Section 10 has the
installation drawings of the Tool Bit Set-Up.
CAUTION
CAUTION: Do not touch the tool bits with your hands. The tool bits are very sharp and
can cut or puncture your skin. Be sure to use gloves when you handle tool bits.
CAUTION: Do not use dull tool bits or tool bits that are not made by Tri Tool Inc. If you use
these bits the clamshell may perform poorly. This constitutes abuse of the equipment
and may void the warranty.
1. Be sure that the wall thickness plus 3/4” (19.0 mm) of Tool Bit protrudes from
the end of the Tool Holder.