TRI TOOL INC.
92-1739 Rev. 220506
14
5. MAINTENANCE
BEFORE AND AFTER YOU USE THE EQUIPMENT:
1.
Wipe the equipment.
2. Examine the equipment for loose or missing parts and for damage.
3. If the weather is humid, spray the equipment with rust preventative.
AFTER EVERY 20 HOURS OF OPERATION:
•
Coat the components with a light film of oil, refer to the arrows in Fig 2. Use a
clean, non-detergent oil, such as SAE 10 (90 SSU) or lighter.
• Lubricate the Male and Female Tool Block Slides and Feed Screw(s).
AFTER EVERY 40 HOURS OF OPERATION:
• Clean and lubricate the Main Gear, Drive Gear,and Tripper Block Assembly.
AS NEEDED:
• If the Tool Blocks collects debris, clean the Tool Blocks and Feed Screws
after operation.
• If there are feed problems, clean and examine the Tool Blocks.
•
If Headstock becomes loose on the Clamshell, readjust the 90° Vee
Bearings, Section 5.
Periodic Maintenance
Figure 2: Tool Block Lubrication