TRI TOOL INC.
92-1739 Rev. 220506
22
Adjust Tool Holder
CAUTION
CAUTION: If you over stress the Mounting Brackets when you adjust them off of the
Clamshell, the Slide Rails may become loose.
TOOL HOLDER
HOLD DOWN
SCREWS
ADJUSTMENT
SET SCREWS
ADJUSTMENT
RAIL
FEED
SPROCKET
Figure 8: Tool Holder Adjustment
1. Be sure that the Tool Module is mounted firmly.
2. Loosen the Hold-Down Screws on the Adjustable Slide Rail.
3. Move the Tool Holder to the most outward position.
4. Use the Adjustment Set Screws to apply a light force to the side of the
Adjustable Slide Rail until is in positive contact with the Tool Holder.
5.
Only adjust the screws that are in line with the Tool Holder.
6.
Tighten the Hold Down Screws to about 12 in-lb (1.4 Nm) to 24 in-lb (2.7 Nm).
7.
Use a hex key to finger tighten the Hold Down Screws.
8. Use a hex wrench, to move the Tool Holder to the inward most position. Note
any changes in the feed pressure.
9. Adjust the remaining Adjustment Set Screws so that the Tool Holder has a
smooth, even feel.
10.
Run the Tool Holder the full length of the Slide Rail.