TPS Hardware Specification and Installation
30
Attach the power cord retention bracket
Follow this procedure to attach the power cord to the retention bracket:
Procedure
1.
Fold the power cable and slide it into the slot.
2.
Push the folded cable into the slot until the cable loop goes past the sheet metal tabs.
3.
Secure the folded cable loop under the sheet metal tabs and attach the power cable to the power supply.
Remove the bracket
If you need to remove one of the brackets, pull the spring-loaded plunger in the middle of the bracket and slide the bracket
up and off the shoulder rivets.
External user disk
The following topics provide information about the external user disk (CFast or SSD):
•
•
•
External SSD
The TPS TX Series devices come with a pre-formatted external SSD.
Use the 32 GB external SSD to store traffic logs, snapshots, and other system data.
Only SSDs available from TippingPoint have been validated to achieve optimal performance with TippingPoint products.
Other vendor drives are not supported. Using other vendor drives could be detrimental to proper operation of the
TippingPoint system.
You can replace the SSD when the system is operating.
CAUTION!
Before you remove the SSD, use the device CLI to first unmount the drive. Failure to properly remove the TippingPoint SSD can
result in disk corruption and a system error.
about using the external user disk commands.
After you insert a new SSD module into the SSD slot, be sure to mount the user disk using the device CLI. Failure to mount
the user disk prevents the device from automatically mounting the disk when you reboot the device.
External CFast storage card
The TPS 440T and 2200T devices come with a pre-formatted external CFast storage card.
Use the 8 GB external CFast card to store traffic logs, snapshots, and other system data.
Summary of Contents for TPS 2200T
Page 1: ......
