TPS Hardware Specification and Installation
26
1.
Removal Latch
2.
Handle
3.
Status LED
4.
AC male power input
The Status LED is green when the module is powered and running normally.
Connect the AC power supply
When the AC power supply has been securely placed in the device, use the following procedure to connect power to the AC
power supply:
Procedure
1.
Locate the male power input on the back of the chassis.
2.
Plug one end of a standard female power plug into the power input.
3.
Plug the other end into an AC outlet, power strip, or UPS. Learn more about the power requirements for your product:
•
TX Series devices –
•
2200T device –
.
•
440T device –
The TPS device returns to its previous power-on state in the event of a power interruption. If power was on when the
interruption occurred, the device automatically powers back on when the power is reconnected; if power was off, the
device stays off when the power is reconnected. If necessary, power on the device with the button on the front of the
chassis.
DC power supply – TPS TX Series
The TPS TX Series devices are NEBS compliant and can accept a combination of AC and DC power supply units. Consult
your TippingPoint account contact for more information on obtaining DC power supplies.
WARNING!
Do not attempt to install a DC power supply into a 440T device. The 440T device does not contain the grounding capability for safe
installation of a DC power supply. Bodily harm and damage to the system could result.
Connect the DC power supply
WARNING!
When installing the product, always make the ground connection before applying power to the unit. You must ground this
equipment to an external ground connection. Use a green and yellow 12 AWG ground wire to connect the host to earth ground
during normal use. Disconnect the ground connection only after the unit is completely powered down.
Summary of Contents for TPS 2200T
Page 1: ......
