TPS Hardware Specification and Installation
22
Procedure
1.
Locate the power inlets on the back of the chassis.
2.
Plug the female end of a standard power cord into the power inlet. Plug the other end of the power cord into an AC
outlet, power strip, or UPS.
Add the I/O modules – TPS TX Series
TPS TX Series devices come with blank modules inserted into I/O module slots. The TPS 8200TX provides two I/O slots
and the TPS 8400TX provides four I/O slots.
WARNING!
Do not leave slots empty for an extended period of time. Insert a blank module or I/O module so that the device can be correctly
cooled.
about I/O module installation.
Procedure
1.
To remove the blank module, slide the slide latch (
1
) to the right and pull on the handle (
2
on left module) or grab point
(
2
on right module).
CAUTION!
Never lift your device using the module handles.
2.
To insert an I/O module, slide the module into the empty module slot.
When the module is in the correct position, the slide latch automatically slides into position.
When you insert a bypass I/O module, the bypass I/O module always starts up in bypass mode. A bypass I/O module
remains in bypass mode until you remove it from bypass mode through the CLI, LSM, or SMS. Rebooting the TPS device
does not change the bypass mode of the bypass I/O module. For information about how to use normal mode instead of
bypass mode, refer to the SMS, LSM, or CLI documentation.
Summary of Contents for TPS 2200T
Page 1: ......
