-15-
(5) protection cover of cushion
adjust the protection cover to the cushion , fix the by
screws.
(6) Operating light
Open the package box of the lamp arm, and connect
them in turns according to the figure
Take out the operating light, and screw off the
M5 hex socket from the connecting spindle. As in the
figure 2, the decorating ring is covered the
connecting spindle, connect those plugs from the
operating light connecting spindle to the light arm
connecting spindle (Note: make sure connecting the
correct color wires , and put the insulated cover on
them.) insert the wires and plugs in the light arm,
finally, insert the operating light connecting
spindle to the operating light arm
Decorating ring
Lamp post
Decoratingring of
Light arm
Fixed Axle
Plug
figure 1
Lamp Arm
Lamp Arm
Decorating
Ring of light
arm
Plug
Operating
Lamp
figure 2
(7) Power unit
Connect the water supply tubing , air supply tubing
and drainage tubing to water source , air source and
drainage respectively. During the connecting, make
sure that the seals of the connecting joints for water
supply tubing and air supply tubing keep in good
condition to avoid the leak of water and air. Connect
the ground wires to the earth.
According to the position where the unit is installed,
air tubing , water tubing should reach the designated
position. Water tubing and air tubing should be adopt
water pipe in 8x5 PVC(ZG1/2”)external diameter,
being connected by elbows. wastewater pipe with inner
diameter greater than 52 mm. As the diagram on the
right.
Note:
1.The drainage tubing should be under the ground at least in
10MM, otherwise, the back current will be caused in the
drainage tubing.
2. The outfall shall be declined for the fluent current.
3. The outfall shall not be twisted, raised or undulant, or put
in the water.
Seat cushion
Protective cover
Adjusting
Screw
Summary of Contents for TR-KID-7
Page 13: ...11 Fuse label...
