Traub TNL20, Operating Instructions Manual

Page: 52 / 74

52
Transport and installation
TNL20
DTE022DE - 24.06.2021
Installation of the machine
• Tighten the adjusting screw D .
• Secure the adjusting screws with the hexagonal nuts
• Screw the two connection brackets to the machine base positions provided
for this purpose; the connection brackets must be adjusted at the bottom.
M16x45 screws and washers (2x each)
Tightening torque max. 80 Nm
• Use an 18 mm dia. masonry drill to drill a 125 mm deep hole in the founda-
tion through the holes in each of the two connection brackets.
• Insert a mortar cartridge and threaded bar (M16x250) (included in machine
accessories). The length of the threaded bar may need to be adjusted.
Follow the documentation of the manufacturer of the mortar
cartridge.
• After the mortar cartridge curing time specified by the manufacturer, secure
the machine to the threaded rods using the hex nuts and washers.
Tightening torque max. 80 Nm.