TransAct POSJET 1500, Programmer'S Manual

Page: 70 / 294

Control Codes POSjet
®
1500 Programmer's Guide
Page 56 Rev M Nov-07
If active, a false CTS prevents the printer
from sending any data to the host
Not Used •
CTS Signal
Active
The multi-drop feature is activated at power up
when set to an address.
This option is available in
PcOS, M50 and Microline
only.
Off •
A Device
B Device
Multidrop
C Device
Validation Control
Slip Auto
Reload
If this option is set, the printer will remain in
validation select mode until the form is inserted
correctly. If this mode is off the printer will
report an error to the host is the slip is not
inserted correctly. If this option is off, the host
must assure that the form is correctly inserted
before the validation information is sent to the
printer.
On
Manual Slip
Load
By default, pressing the FORM button will
cause the printer to enter validation mode. This
feature may be disabled by turning this option
off.
ON
Auto Journal
Slip
If this option is selected, any information printed
on a validation form will also be placed in the
Electronic Journal.
Off The Electronic Journal must be
active for this option to function.
Allow Form
Abort
By default, pressing the FORM button while the
printer is requesting a form will abort the form
request and return to receipt mode. This option
will disable this feature
Enabled
Form Insert
Timer
This sets the time the printer waits for a
validation form before returning to receipt
mode.
• Disabled to 10 Min.
Form
Remove
Timer
This sets the time the printer waits for a
validation form to be removed before returning
to receipt mode
• Disabled to 10 Min.
Note: There is a 1 Second Option
that is useful in some systems.
Default Slip
Stop
This specifies the default load point for
validation forms.
40 mm. This value should not be set
greater than 40mm unless the
inserted form will always be less
than 70mm (2.75”) wide.
M50
Validation
This option is available in M50 and Microline
emulations. It compresses the print (Vertically)
to allow applications written for the M50 to print
the same number of print lines on the 1500
Normal M50 and Microline only
Validation
Left Margin
This options sets the default left margin in
validation mode.
0
100 ms. to
1 Sec.
100 ms. to 1 Sec.
Form Sense
Delay
This sets the time the printer waits after a form
is sensed until the form is loaded.
• 300 ms. to 1 Sec.
Electronic Journal