Installation - Controls
54
UNT-SVX041D-EN
After the channel scan is finished, LED3 begins blinking
(one-blink pattern) to show that the receiver is ready to be
associated with a sensor.
Associating Sensor to Receiver
To associate the sensor to the receiver:
1. Remove the sensor cover by firmly pressing the thumb
tab at the bottom of the cover and pulling the cover
away from the back plate.
2. Verify that the sensor is set to the same address as the
receiver it is to be associated with.
3. Power the sensor by removing the insulation strip from
between the two batteries.
Association is automatically initiated between the sensor
and the receiver. When LED3 on the receiver stops
blinking, association has been established.
If the first association attempt is unsuccessful, the sensor
automatically re-attempts association with the receiver
every 10 minutes.
Note:
An associated sensor that has lost communication
with the receiver will transmit an association
request every 50 minutes. You can manually
initiate association (see
Testing Signal Strength and Battery
To verify that the association process was successful and
that the batteries have adequate charge:
1. Firmly press and release the Test button on the bottom
of the sensor as illustrated in the figure below.
2. For model WZS, view LED1, LED2, and LED3 to
determine the signal strength. View LED5 to determine
the battery status (see the figure below for model WZS
sensors).
Note:
The LEDs will turn Off after 5 seconds to
conserve battery strength.
Figure 47.
Receiver conducts 20 second channel scan
Figure 48.
LED3 blinks after channel scan to show
receiver is ready
0
20
Sec.
LED3
Figure 49.
Power sensor by removing insulation strip
