B
SEATING AND OPS
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
75
Repair and Service Manual
10002660
SEATING AND OPS
SEATING
NOTICE: Complete seat removal and replacement is
not necessary in some of the repair procedures.
Remove and replace the seat bottom or seat back
assembly only if necessary.
Front Seat Removal and Installation
Front Seat Bottom
Lift and tilt the seat bottom toward the front of the vehicle,
and remove the seat bottom.
To install the seat bottom, insert the seat tabs in the slots
in the seat frame, and lower the seat bottom in position.
Front Seat Back and Support
Tool List
Qty.
Ratchet ........................................................................ 1
Socket, 7/16 ................................................................ 1
Socket, 9/16 ................................................................ 1
Wrench, 9/16 ............................................................... 1
1.
To remove front seat back (9), remove four screws
(11) and lock washers (12) securing the seat back to
the lower OPS (Ref. Fig. 1).
2.
Remove the four lock nuts (8), washers (7), and bolts
(6), from the seat back support (5) (or lower OPS).
Assemble in the reverse order of removal.
Tighten the bolts (11) to the torque values specified
below.
Fig. 1 Front Seat Back Removal
Rear Seat Removal and Installation
Tool List
Qty.
Socket, 7/16”................................................................1
Socket, 9/16”................................................................1
Ratchet ........................................................................1
Wrench, 7/16” ..............................................................1
Wrench, 9/16” ..............................................................1
Torque Wrench, ft. lbs..................................................1
Torque Wrench, in. lbs. ................................................1
1.
Remove the two bolts (15) and lock nuts (16) secur-
ing the armrest (14) to the seat frame (Ref. Fig. 2).
2.
Remove the bolts (36) and lock nuts (16) securing
the armrest (14) to the footrest (24).
3.
Remove the armrests (14) from the rear seat (Ref.
Fig. 2 Arm Rest Removal
Item
Torque Specification
11
13 - 16 ft. lbs. (18 - 22 Nm)
8
30 - 33 ft. lbs. (40 - 45 Nm)
9
11
12
Lower
OPS
6
7
8
5
Front of Vehicle
14
15
16
Front of Vehicle
36
24
