B
92
Repair and Service Manual
FAULT TESTING
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
10002660
CURTIS CONTROLLER
General
Use the Curtis handheld programmer for programming,
fault testing, tuning, diagnosing and adjusting parameters
for the speed controller and auxiliary devices (Fig. 2).
Fig. 2 Curtis Handheld Programmer
Connect the Curtis handheld pro-
grammer power cord to the Curtis
programmer port only. If connected
to the wrong port, voltage from other interface cir-
cuits can permanently damage the programmer.
NOTICE: The port on the passenger side is for the
master controller; the port on drivers side is the
slave controller.
Fig. 3 Curtis Programmer Port
Fig. 4 Curtis Programmer Port Installation
Connect the Molex plug to the receptacle on the face of
the controller.
Navigation
A blinking square on the left indicates the position of the
cursor.
The blinking square moves
vertically when the up or
down arrow on the naviga-
tion key is pressed.
Press the right arrow on the
navigation key to display a
column of sub-menus. Press
the right arrow a second
time to display more than
one level of sub-menus.
Changing Data Value
Press the up or down arrow on the data
value key to change the value of the param-
eter.
Favorites
Press a favorites (star) key for four seconds
(until the favorites set screen is displayed),
to set a position in the menu.
Press the appropriate favorites key to move
to a selected favorites position.
Display
Screen
Data Increase
Soft Keys
or
Data Decrease
Key
Power, Favorites,
Menu, and Help Key
Power
Cord
Navigation
Key
UP
DOWN
RIGHT
LEFT
