B
MOTOR
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
69
Repair and Service Manual
10002660
MOTOR
GENERAL
Do not use the accelerator and
motor to hold the vehicle on a hill.
Leaving the motor in a stalled con-
dition for more than 3-4 seconds can cause perma-
nent damage.
Disassembly of the motor is not recommended.
Neither the motor housing nor armature are available as
service items, therefore in the unlikely event of a failure in
either component, the entire motor must be replaced.
Motor Brake Removal
Tool List
Qty.
Wrench, 10mm ............................................................ 1
Insulated Wrench, 9/16” .............................................. 1
Insulated Socket, 9/16”................................................ 1
Ratchet ........................................................................ 1
1.
Use an insulated wrench to disconnect the negative
(-) battery cable from the battery (Ref. Fig. 2).
2.
Disconnect the harness from the motor brake con-
nector (7).
3.
Remove the three bolts (5) and washers (4) that
secure the motor brake (3) to the motor (1).
4.
Remove the motor brake (3) (Ref. Fig. 1).
Fig. 1 Motor Brake
Motor Brake Installation
1.
Verify that the seal is in place and that the mounting
bolts pass through the holes without any interfer-
ence.
2.
Apply a small amount of anti-seize to the armature
shaft.
3.
Install the motor brake onto the motor leaving the
bolts loose.
4.
Connect the wiring harness.
5.
Reconnect the negative (-) battery cable.
6.
Turn the key switch on and set the park brake switch
to the “RELEASE” position.
7.
Tighten the bolts to the torque values below.
8.
Return the park brake release switch to “RUN”.
3
5
4
1
7
