Toyota Sienna 2004, Owner'S Manual

Page: 263 / 505

04 SIENNA_U (L/O 0408)
257
2004 SIENNA from Aug. ’04 Prod. (OM45422U)
2. Remove the discharged batteries and
put in the new batteries as shown.
Install the cover.
NOTICE
!
Be sure that the positive side and
negative side of the controller bat-
tery should be faced correctly.
!
Do not replace the battery with wet
hands. Water may cause rust.
!
Do not touch or move any compo-
nents inside of the controller, or it
may interfere with proper operation.
!
Be careful not to bend the electrode
of the controller battery insertion.
!
Close the battery case securely.
After replacing the battery, check that the
controller operates properly. If the control-
ler still does not operate properly, contact
your Toyota dealer.
The DVD player can play audio CDs,
DVD video discs, CD texts, dts
− CDs
and video CDs.
For appropriate discs for this player, see
“Car audio/video system operating hints”
on page 292 in this Section.
The DVD player works when the ignition
key is in the “ACC” or “ON” position.
To turn on the DVD player, a disc must
be loaded in the player.
To turn off the player, eject the disc.
Error messages
If the player malfunctions, your audio sys-
tem will display one of the three following
error messages.
If “DISC CHECK” appears on the
screen:
It indicates that the disc is dirty,
damaged or it was inserted upside down.
Clean the disc or insert it correctly.
If “REGION CODE ERROR” appears on
the screen:
It indicates that the DVD re-
gion code is not set properly.
If “DVD ERROR” appears on the
screen:
There is a problem inside the
player. Eject the disc. Set the disc again.
If the malfunction still exists,
take your
vehicle to your Toyota dealer.
—DVD player