Toyota Sienna 2004, Owner'S Manual

Page: 326 / 505

04 SIENNA_U (L/O 0408)
320
2004 SIENNA from Aug. ’04 Prod. (OM45422U)
Programming an entrance gate/program-
ming all devices in the Canadian market
1. Decide which of the 3 HomeLink
"
but-
tons you want to program.
2. Place your hand − held gate/device
transmitter 25 to 75 mm (1 to 3 in.)
away from the surface of the
HomeLink " .
Keep the indicator light on the HomeLink
"
in view while programming.
3. Press and hold the selected
HomeLink
"
button.
4. Continuously press and release (cycle)
the hand − held gate/device transmitter
button every two seconds until step 5
is complete.
5. When the indicator light on the
HomeLink
"
changes from a slow to a
rapid flash after 20 seconds, you can
release both buttons.
6. Test the operation of the HomeLink
"
by
pressing the newly programmed button.
Check to see if the gate/device oper-
ates correctly.
7. Repeat steps 1 through 6 for each re-
maining HomeLink " button to program
another device.
Programming other devices
To program other devices such as home
security systems, home door locks or
lighting, contact your authorized Toyota
dealer for assistance.
Reprogramming a button
Individual HomeLink
"
buttons cannot be
erased, however, to reprogram a single
button, follow the procedure “Programming
the HomeLink
"
”.
(b) Operating the HomeLink
"
To operate the HomeLink
"
, press the
appropriate HomeLink
"
button to activate
the programmed device. The HomeLink
"
indicator light should come on. The
HomeLink
"
continues to send the signal
for up to 20 seconds as long as the
button is pressed.
(c) Erasing the entire HomeLink
"
memory (all three programs)
To erase all previously programmed codes
at one time, press and hold down the 2
outside buttons for 20 seconds until the
indicator light flashes.
If you sell your vehicle, be sure to erase
the programs stored in the HomeLink "
memory.