TOYOTA
TUNDRA
2010 -
TVIP V4
Procedure
REMOTE ENGINE STARTER (RES)
Page 29 of 44 pages
Issue: E 04/07/10
USE ONLY FOR VEHICLES WITH
ELECTRONIC STEERING TILT. (steps i-q)
(i) Secure the V4 Harness to the Vehicle
Harness with 2 Wire Ties as shown.
(Fig. 7-5)
(j) Open up the White Cable Routing Box.
(Fig. 7-6)
NOTE:
Do not damage the clips excessively.
They will discolor slightly but should not be
broken.
(k) Locate and secure the V4 Harness’s 2 Red
Tape Markers to the Vehicle Harness using
2 Wire Ties as shown. (Fig. 7-7)
(l) Loop the V4 Harness once inside of the
White Cable Routing Box. (Fig. 7-7)
(m) Close the White Cable Wire Routing Box.
(Fig. 7-8)
(n) Locate and disconnect the Vehicle’s White
8P Ignition Connector. (Fig. 7-8)
(o) Plug in the V4 Harness’s 8P Connectors in
between the Vehicle Harness’s 8P
Connector and the Ignition Switch
Connector. (Fig. 7-8)
Fig. 7-7
White Cable
Routing Box
Side Cutter
Red Tape
V4 8P Connector
Wire Tie
Red Tape
Wire Tie
Fig. 7-8
Vehicle 8P Connector
White Cable
Routing Box
V4 8P Connector
Fig. 7-5
V4 8P Connector
Wire Ties (x2)
Side Cutter
Fig. 7-6
V4 8P Connector
Flat Blade Screwdriver
White Cable
Routing Box
Fig. 7-8
Vehicle 8P Connector
White Cable
Routing Box
V4 8P Connector
